Replacement Adhesive Strip for 3 Cups Toothbrush Holder Wall …
In stockShips via authorized retail partners
At a glance
- Cut to the 3-cup footprint
- Holds in a wet room
- Stronger as it works
- A minute, no drill
Adhesive is the one component of a wall-mounted holder with a genuine reason to be replaced. Flats change, walls get repainted, a unit that lived two years on tile has to go up again somewhere else. Retiring a perfectly good dispenser because its back is no longer sticky is a poor trade, which is why the strip is sold on its own.
Orders are fulfilled by our authorized retail partners; shipping and returns follow the partner’s standard policies.
Owner’s notes
Cut to the 3-cup footprint
Shaped for the three-cup holders rather than sold as a generic roll, so the bond covers the same area the factory strip did and the load sits where it was designed to.
Holds in a wet room
The non-marking strip grips metal, wood, mirror and ceramic tile and keeps its grip in humidity — the condition that defeats ordinary tape within a season.
Stronger as it works
The longer the strip carries weight, the tighter the bond becomes, and it peels away later without leaving residue on the wall behind it.
A minute, no drill
Clean the surface, press, done — no holes, no dust, no landlord conversation. Textured walls and wallpaper are the exception: adhesive cannot honestly hold those.
Also in the range
Replacement Adhesive Strip for 4 Cups Toothbrush Holder Wall …
A replacement adhesive strip cut for the 4-cup wall holders — same bond, sized for the wider family panel.
Replacement Adhesive Strip for Wall Mount Toothbrush Sanitize…
A replacement adhesive strip for the wall-mounted UV sanitizer holders — for the heavier, battery-carrying units.
